Thx for the info Mark. That's new to me and I'll be using it soon on a dresser project with curved sides.
Stand for something, or you'll fall for anything.
Question: Would guide rails on the edges be necessary, or does the work just go straight on it's own?
I use a melamine surface on mine, but sometimes the work rides to the side....no vac holes. This looks like something I need to try.
Thanks,
Rick Potter
DIY journeyman,
FWW wannabe.
AKA Village Idiot.
No guide rails needed. The suction is pretty impressive and there is not much movement at all of the veneer/laminate.
Thanks Mark, I will give it a try.
Rick Potter
DIY journeyman,
FWW wannabe.
AKA Village Idiot.
In his design, Brial uses slots and you used holes. Are there any advantages/disadvantages of one over the other?
Instead of removing the table, a thin strip of metal fastened right at the end of your vacuum box would fit down between the hinged table and the planer bed.
Lee Schierer
USNA '71
Go Navy!
My advice, comments and suggestions are free, but it costs money to run the site. If you found something of value here please give a little something back by becoming a contributor! Please Contribute
Great idea !!! Will use it in future... THANKS
A question: has anyone tried using one of these vacuum boxes in an attempt to eliminate snipe on, say,4/4 stock after one side is jointed smooth?
Cherry to a thin 1/16 inch, about 0.06 Uniform grain helped
veneer 1.jpgveneer 2.jpgveneer 3.jpg
Very interesting jig.
If I understand what's happening, the suction is sufficient to hold down the thin workpiece, enough to keep it from rising into the cutters and getting destroyed, but not too much suction to prevent the rollers from moving it through. If I have it right, then very clever and I look forward to giving this a try. Thanks for sharing!
Edwin
You are welcome Edwin. This morning I peeled off a 1/32 inch veneer from my bandsaw and ran it through the vacuum box afterwards. I don't have a caliper but I estimate I was at 1/40 inch. My cherry grain was ideal this morning. I do not think I can reliably get 1/40 inch but it can be done.
veneer thin 1.jpgveneer thin 2.jpgveneer 3.jpgveneer 4.jpgveneer 5.jpg