I have ground the shank down on some taps so they can pass through the work piece.
Screen Shot 2022-03-05 at 5.13.14 PM.png
I have ground the shank down on some taps so they can pass through the work piece.
Screen Shot 2022-03-05 at 5.13.14 PM.png
Last edited by Maurice Mcmurry; 03-05-2022 at 6:18 PM.
8/32 is pretty small. If you're tapping 1" deep there is a strong likelihood that you'll break a tap.
The spiral pointed gun taps recommended by Tom are probably your best bet.
I will check the taps I have at work tomorrow and get back to you on this.
Tom