I opened the top and I must have run the planer without the dust collect port open. Full of saw dust. Took off the shroud and cleaned everything out and even used a tooth brush to clean around the sprockets I could reach. There is one post/sprocket behind the motor that I can't get too and when I lower it, it will not let me go below 1-1/2". I am assuming I have crap built up in the corner not letting it lower all the way.
I have the chain covers on each side off for the rollers and the chain for the height adjust travels, although with some resistance. Do I remove the motor from the inside or is there a way to leave it in place and remove the yellow cover around it to clean it out?
Thanks.
Brian