Folks, could you help me design a CNC setup for cutting these various curved rafters only? The CNC shop I usually take these to has been so busy the last few years that it sometimes takes weeks to get them back.
The widest pieces I'm cutting is 2x12, the longest would be 12' so I’m thinking a 2’ wide x 12’ long table. Could the router travel up and down a single strongback above the table? I only work with clear wr cedar and Calif. redwood ~ 2” thick so don’t need a powerful motor. I'm hoping to just set the CNC table on one of my shop benches when I need to use it.
How do I get started with this design? Are there any good resources I could check out?