New to the forums and first time poster. I am ready to upgrade my table saw. Almost anything would be an upgrade from my direct drive Craftsman. I can’t afford to buy a new cabinet saw. I’m trying to be patient and wait for a used 3hp cabinet saw. I’ve seen a Rockwell 34-450 for $550, a Jet JWCS-10 for $600 and an Atlas 3160 for $200 (tempting but old and hard to find parts?) but there are also Hybrid Jets for $600 with a 1.75 hp motor.
My intention is to put an Incra TS-LS system on a saw.
I read somewhere, concerns regarding kickback with right tilt saw while using a right hand rip fence??? The majority of the Delta’s (and their knock offs) are right tilt??
Any advice would be appreciated regarding older saws and concerns regarding the right tilt?