[OP]
Contributor
Missing the fence and spacer strip on a craftsman pro RAS 315. I just picked up. I can guess on the dimensions but if someone has the width much appreciated. I suspect the fence would have been same material 1” and probably 2” high. I know the length.
Thanks
Contributor
going from memory the 3 piece table was 1" manmade material, and the fence was a piece 3/4" thick by 1 1/2 or 2" pine? (solid wood) no knots. watch the height as need motor clearance.
As I remember, cannot get down to the basement shop at this time to check and for at least 4 more weeks.
Ron
The fence is available at ereplacements.com
Lee Schierer
USNA '71
Go Navy!
My advice, comments and suggestions are free, but it costs money to run the site. If you found something of value here please give a little something back by becoming a contributor! Please Contribute
Contributor
Craftsman Professional? That's been funny since the day they added on the word. Ever see one in a cabinet shop?
Contributor
Make the fence from 6" material and notch the right hand side for motor clearance as needed.
Bill D
Posting Permissions
Reply With Quote