Since one end looked the best, I started there,
May Project, stile layout, start here.jpg
Just hold them square...use one of the 2" wide rails...mark where the tenon meets the groove...square a line across...
May Project, Stile layout, lines.jpg
then, mark for the raised panel....then a rail..and continue down to the bottom..
May Project, Stile layout, need trimmed.jpg
End with another 2" wide rail...add 3" below that for a Foot...after that?
May Project, Stile layout, need trimmed.jpg
Is to be cut off as scrap...a pattern for the foot?
May Project, Stile layout, foot pattern.jpg
Which can wait a bit...
Stay tuned..