Set one stile on the bench and into the jig....it was marked for "INside" so set that face away from me...then glue on tenon, and a spot of glue in the center of a panel..and worked my way down to the other end of the Stile..then add glue again to all the "upper" tenons and a small spot in the panel's centers...then a Mallet assist to install the matching Stile...and then add the clamps..working towards the middle..
May Proj.,Thurs., outside, glue-up.jpg
Had a couple tenons that didn't want to enter their mortises...Mallet to assist that problem...
May Proj., Thurs., inside, glue-up.jpg
The 2 red c clamps to close a gap on the end,,,and help center things up better...added a few other 6" f clamps for the same reasons Mainly to center the rails in the stiles..

letting this sit a day...next up?
May Proj., Thurs., Tomorrow's.jpg
Have the #1 and #2 Stiles...they both need a foot profile sawn, and 9 mortises chopped...then the Raised Panels and the rails can be made ready for the next big glue up..

Stay tuned..