Hello, I'm bit of a moulding plane nut. Which means, I should probably go and buy a book on it....
but till then I was hoping someone could enlighten me on this moulding plane I picked up at the markets.
I sharpened it and ripped out its profile on a bit of scrap.
I know it looks to be a pretty simple design, and what it was used for is probably staring me in the face....but its got me scratching my head a little.
I'm thinking, its not a regular bead plane, cause its got a flat extending from the edge to the start of the bead.
...thinking, it could be for beaded T&G joints for wall paneling or the like, but then the quirk seems too wide. ...and the tongue bit too.
So, where was this profile used......and ultimately how can I use it ! ,, if it all.
Appreciate any thoughts. Ta.