Results 1 to 2 of 2

Thread: Cutting Extira

  1. 03-25-2008, 7:53 AM #1
    Bob Reda's Avatar
    Bob Reda
    Bob Reda is offline [OP] Contributor
    Join Date
    May 2004
    Location
    SW PA
    Posts
    345

    Cutting Extira

    Has anyone cut extira with their shopbot? If so what is the best type of bit to use?

    Thanks
    Bob
    Reply With Quote Reply With Quote
  3. 03-25-2008, 6:54 PM #2
    Peter Meacham
    Peter Meacham is offline Friend of the Creek
    Join Date
    Dec 2006
    Location
    Santa Maria, CA., USA
    Posts
    480
    Bob

    You might ask that question over on the ShopBot forum, if you have not already - lots of people have cut it over there.

    Pete
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Cutting board...
    By David Harvey in forum Laser Engraving General Topics
    Replies: 6
    Last Post: 04-06-2007, 2:53 PM
  2. Sheet goods cutting station for new Festool saw. Foam board make sense?
    By Larry Rasmussen in forum General Woodworking and Power Tools
    Replies: 13
    Last Post: 03-30-2007, 9:53 AM
  3. Carter Guides on a wood/metal cutting bandsaw.
    By Chris Rosenberger in forum General Woodworking and Power Tools
    Replies: 5
    Last Post: 01-23-2007, 12:52 PM
  4. Cutting board question
    By Ken Miller in forum General Woodworking and Power Tools
    Replies: 7
    Last Post: 03-20-2005, 9:18 PM
  5. cutting board glue up
    By Mark Rios in forum General Woodworking and Power Tools
    Replies: 7
    Last Post: 06-01-2004, 8:57 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules