Brian, as always, pretty awesome. I also think that the blog format is much cleaner and easier to navigate (another 'at-a-boy', lol). Thanks for sharing - I can't wait to see the arm support!
Brian, as always, pretty awesome. I also think that the blog format is much cleaner and easier to navigate (another 'at-a-boy', lol). Thanks for sharing - I can't wait to see the arm support!
I'll keep that in mind as I start to purchase broad axes....they're multi-purpose!
I tried wood weld, and I have no honest complaints about it, my glue lam separated mostly because I used material that was too heavy. However, my major complaint with powder glue is that it requires me to get the mixture right, something I am lousy at. I mixed to the recommended amount but gut instinct was that it was too thin.
I had a few people comment that they've had fine luck with Titebond III for glue lams, and also for outdoor purpose and so I decided just to go with something I've had more experience with. I've also had a table outside, with that involves multiple glue ups and it's been left out uncovered for 5-6 years. It's pretty basic and honestly under-built and still it doesn't flinch at 3' of snow or being in sunlight for the majority of the day.
Thanks John!
Glad to hear from both of you that the format is improved. The menu bar still needs my attention, I'd like to have drop downs like the previous format, but I felt the top bar on the previous format was cluttered looking, so I'm glad to do away with it.
It also annoyed me that the tagline would be on the right hand side of my name, which I thought was very strange. I like it centered under the name as it is now.
Of course I had to pay money for this format, which also why it took me so long to move from a basic free format....lol.
Bumbling forward into the unknown.
Brian, I doubt you mixed it too thin. The way we use it for that particular purpose is so thin that it will immediately drip ,not run off a stick. A thick coat on one surface won't work ,both surfaces need to be coated. The glue spreads and works better if you let it sit at least ten minutes after mixing. I'm pretty sure that used to be on the label ...but that was a long time ago. That makes a big difference on materials like Italian bending ply which are saturated with glue during manufacture; the rest makes the glue cover evenly. With out the rest the glue will kind of bead up ,resisting an even coat and requiring more spreading. Yes, the glue can go bad if not carefully stored. The container top needs to be replaced quickly, not after you have mixed what you need now! When buying 25 pound containers I have taken as long as two years to use it all. I put in some silica gel ,put container in thick plastic bag and store it in the office,not shop. I even put a piece of metal on for temp top while weighing it out. I asked a guy at the company if all that would keep it good. He said "yeah,if you're willing to do all that!" And I asured him I was. And I've bought and used a lot of it.
Last edited by Mel Fulks; 02-17-2017 at 12:19 PM.
Thanks Mel, appreciate your insights. I did not know if thinner was better or worse than thicker, which was the majority of my concern.
It should be a better glue for the application but I will likely do away with it unless I start doing enough bent laminations. To want to work out the kinks in my process. Titebond is something I've had much success with so it does offer some reassurance in that context which currently does not exist for me in plastic resin.
I avoid epoxy for similar reasons and I used to use very high quality epoxies on knife handles....fast forward 15 years and I'm repairing that connection. I know it is a different context but I lack trust in certain glues.
Bumbling forward into the unknown.
Brian, the thin mix I described has just a bit more water that what it has if mixed exactly like the mfg directions.