I have a new chiminea firepit on my patio. I also have lots of scrap wood, much of it primed/painted. Can I safely burn this in the firepit?
Thanks!
I have a new chiminea firepit on my patio. I also have lots of scrap wood, much of it primed/painted. Can I safely burn this in the firepit?
Thanks!
In a chimnea outside, I think's probably better than burning it inside, but I'd still try to plane off most of it. Just me.
Burning painted or finished wood can create toxic fumes that you may be inhaling even in an outdoor fire but it also releases those toxins into the air which is not good either.
As suggested above, try planing off most the finish before using it as firewood.
It will not hurt the fire pit in the least.
I used to take scraps and old cabinets to campouts. The camping purists claimed it changed the ambiance from "outdoor nature" to "house fire".
This is one of those questions that if you need to ask, you probably shouldn't do it.
Oh yeah, I'm assuming (maybe badly) that the paint is relatively new (i.e., lead-free paint).
Wow, what a philosophy. Other things do damage so we should just do what we want and forget the consequences.
Man is already toxic to the planet so we might as well continue.
To the OP, if you really want to burn the wood you should remove any potentially toxic finishes first and that is not limited to non-leaded paint. The chemicals in many finishes and paints are extremely hazardous when burned. You could run it across your table saw to skim off the outside layer. If it is too small to do that then you do not gain any real benefit from that small amount of wood you would be burning and certainly not enough benefit to risk your and others health let alone the pollution that settles into rivers lakes and oceans and comes back to us in the food chain.
Not sure how bad it is for you, but I do it all the time - especially since I have to pay by the can for garbage pickup. I usually make sure I am not burning any lead paint - I also burn ply - which I am sure I am about to get a dressing down over -
I make sure I don't stand over the fire when that kind of stuff is burning.
Wow is right!
I asked you where to draw the line and you did not see the best place...
The solution it to bury at a landfill, the environmentally correct answer
Why use more energy to to remove the paint to burn it, when burning wood that will give off more toxic fumes than a cigarette?
Carpe Lignum
I don't burn plywood or anything finished...anywhere. Why? Because I don't know everything that went into the finish/glue and I'm too lazy to look it up.
I don't have a problem with burning plywood or finished wood, but I wouldn't do it in a campfire-type setting or cook over it. The toxins released are pretty minimal. Most of it ends up as ash in the pile. I do prefer to get the fire good and hot first, then add anything with finish on it--more heat means more breakdown in the chemicals.