Have you had a situation where the imported plate is so complex that sections of the graphic are left out of the preview/job.You have to reduce the dpi way down to get the entire job and sometimes that does not do it. Sent the file to Trotec and they could not see a problem. Like its a memory issue but it happens on small jobs like nametags with a jpg logo.I use Corel 9 and I know that is not the issue. Is there a memory upgrade? (JC 6.2.3) (divers 5.14 & 5.15)Your thoughts........
The PDF show the results between a 500 and 600 DPI image at the laser Job Control preview the twist is not a large file and shown in the CDR attached.