I was a construction lender for many years and am very familiar with this issue. I am in California and here in order for a sub to have lien rights he must file a preliminary lien notice notifying...
Type: Posts; User: glen pickren; Keyword(s):
I was a construction lender for many years and am very familiar with this issue. I am in California and here in order for a sub to have lien rights he must file a preliminary lien notice notifying...
Why don't you put two non-swiveling casters in the middle of both long sides? Mount them to be 3/8" higher than the swivel casters on the ends. That way you can spin the cart on its axis like the...
Most of the houses in Florida are built with cinder block and the interior walls are always furred out for drywall. They have done it for years with wedge shaped concrete nails. Screws should be...
I just picked up one of these. http://www.amazon.com/Dimplex-DGWH4031-4000-Watt-Garage-Workshop/dp/B00064NURU Turned out one of the cheaper internet stores was a few miles away from my home in...
True, I understand the method in the link. My problem is my shop is on the ground floor of a 3 story barn with living space in the upper level. I would have to have at least 26' of chimney pipe...
Sounds like vented is the rule if I use propane. What about the electric 220v heaters?
I would go with a wood stove, but I would need a 26'+ chimney to keep smoke out of living area. Too bad as...
I have an uninsulated 37 x 17 shop that I want to heat on typical 35 to 45 degree days which I get for maybe 3 months. I am in the Sierra Nevada foothills.
I am considering a portable propane job...
Enclosed cargo trailer with ramp door. If on mobile base just roll it up the ramp and tie it with straps inside. If no mobile base, use furniture mover's dolly ($14 @ Harbor Freight). Tilt saw...
Gary, you will like the SharkGuard. It eliminates all of the above table dust.
I noticed you have the mobile base. Did you put blocks in the corners to raise the saw base? My mobile base covers...
Isn't that essentially what Sam's picture shows. If his remote died, could he just pull out the Radio Shack remote, unplug the relay cord from it and then plug the relay cord into the socket below...
My Bosch 4100 TS port is also on the rear. It pretty much has to be because of tilt mechanism on the front. Also, it appears somewhat effective because the blade creates a strong blast of air out...
Cary, I noticed this thread has been inactive for several months but I hope you can answer a couple questions. You mentioned your shroud did not prevent you from being sprayed with dust, even with...