Hey Scott, Yes. Using the Sealer/Finish. The fourth coat went on pretty well. I am thinking that at least another coat (5) before it starts really sealing/leveling and 8-10 before it is smooth. That is A LOT of finish. Have to run back to Woodcraft this weekend because I already almost went through a quart and haven't started on the chairs or the top side of the table.
As for wiping on this finish, one thing that everyone should know is that it dries tacky very quickly. I am finishing in a room that is 70 deg w/ 43% humidity and good airflow. Very upset individual when I wiped on the first coat as quick as I could on the base and went back to wipe off and it was already tacky and would not wipe off without a touch of mineral spirits. Decided to just let it be and I am going to have to sand the entire base with at least at lease (really most) 320. I am thinking that if you have a larger project you need to thin it down by about 10-20% before it will wipe on/off easy before it starts getting tacky. Going back to the brush to finish it up.