Hi all,

Normally I handle my crosscuts on a festool MFT/3 complete with TS55 - I've found that when tuned it produces square results.

30" is too wide to fit on the table, and I'm seeking input on how to accomplish an accurate safe crosscut.

I considered the tablesaw for a minute but it's way too wide to use a miter gauge, and utilizing the fence wouldn't produce a perpendicular cut to the currently perfectly parallel sides.

There's got to be a simple solution that I'm not thinking of.

The piece is 35"Hx30"W - looking to shorten it to 33"Hx30"W.

Thank you.