Tired of being "just off" when it comes to measuring off the edge of a board, I'm looking at getting a T-Square that has holes to put a mechanical pencil through to make accurate, repeatable measurements.
I’ve seen the following and wonder if anyone has any experience with the Pinnacle. I’ve seen a few favorable comments on the Incra and am leaning toward it.
Pinnacle 12” T-Square, which looks sturdy, but the holes are drilled to 1 mm in diameter, which seems would allow the pencil to wobble.
http://www.woodcraft.com/Product/202...2-TSquare.aspx
Incra T-Rule. Less than half the cost, the holes are drilled at a bit of .5 mm, but it seems a bit fragile.
http://www.incra.com/product_t-rules.htm
Thanks,
Eric