Heres a few pics of a couple projects I've worked on in my new shop.
First is a closeup of the lumber rack. The wall was framed with 4x4s which were pre drilled to accept 3/4 galvy pipe. The wall was then sheathed with 1/2" sheeting and the holes were opened with a router flush bit. Very stout and adjustable.
Next couple of shots is of a panel cart on casters. Base is lapped 2x6s, bottom is 3/4 HDO, and the tubing is 1.5" exaust pipe bent for me at the local exaust shop.
Tubing has been painted, and I'll probably wrap the base with some hardwood to protect the sheets from the sharp edge of the HDO.
Note: Even though the casters are 5" swivel, the loaded cart does not move around as easy as I had hoped, but once the casters are lined up it goes OK.
Lumber Rack.jpgCart with Panels.jpg Panel Cart.jpg