This question is very similar to the one about countersinks.....
Observe the picture please:
(I warned you all last week I am good with my camera now, and have a week off....)
DSCN0471.JPG
Left-this one, like the one on the right does better and runs cooler around 1K rpm--is it designed to automatically eject each plug, or am I doing something wrong?
Middle one wobbles terribly all over board if run slower (cause there are only two contact points with board?)
Right-just used it cause it came w the drill combo countersink set.
To look @ the plug, it looks like they cut a tapered, right?
Do you all cut a bunch, leave in the board, and then cover the ends with masking tape, then BS the strip, releasing the plugs?