I hope I am doing this right.
I have designed a pin table to fit my Speedy 300, but as long as your laser can accommodate a 28.725 X 17 inch insert, this should work for you as well. I am offering this up as a group buy to lower the costs associated with getting it made. This will be an AT COST project. I am offering this so we can all take advantage of the lowest possible price for this. I am not the vendor that will be making these plates.
Project Specs:
Each Table will consist of - Quantity 2
- 28.725" X 17" - .125 (1/8) 6061 Aluminum Plates with .125 holes across the table. There is also built in hand holds for easily placing in the table.
I will be offering the plates only but I have the McMaster part numbers that will be needed to assemble the two plates, as well as, the pins that will be needed. There are screws, risers and pins.
I will also provide a corel file that can be used for pin placement for each person who buys in so you can easily place pins on your cut files.
Right now my pricing is as follows. If I can get five people to buy in, the price per set of plates would be $135.98, plus shipping. If we get more than 5 interested, the price will only go down from there. I will provide all information for the vendor making these so anyone interested can verify pricing once we have enough people to proceed. I know something like this could easily be done out of acrylic but I want something durable that will last forever. I am hoping others do to.
Here are some 3D images of the design:
http://www.cutoutlaser.com/wp-conten...017/02/001.jpg
http://www.cutoutlaser.com/wp-conten...017/02/002.jpg
http://www.cutoutlaser.com/wp-conten...017/02/003.jpg
http://www.cutoutlaser.com/wp-conten...017/02/004.jpg
http://www.cutoutlaser.com/wp-conten...017/02/005.jpg
Also just in case there are any concerns about vaporware, here is a one off I did for a friend of mine that has a small Epilog.
http://www.cutoutlaser.com/wp-conten...2/eaton001.jpg
http://www.cutoutlaser.com/wp-conten...2/eaton002.jpg
http://www.cutoutlaser.com/wp-conten...2/eaton003.jpg
http://www.cutoutlaser.com/wp-conten...2/eaton004.jpg