Hi,
I have about 40 pieces of tree limbs. They are 12 - 18" long and a foot or so in diameter. I made a saw buck and was going to cut 4 sides off to make them roughly rectangular. My thought was to save some storage room by making them smaller and to have less shaving and turning mess when roughing. Also, my lathe is only midi size if that and rocks with larger pieces. My band saw isn't big enough to cut round circle chunks unless they are only about 4" in length so I want to use a chain saw and the sawbuck. Is this just a waste of time? Will it affect the drying process negatively? I seal the ends with paint or wax sealer. Please give any advice.
Thank you,
Vicki