I'm a novice and am looking for insight into what I'm doing wrong.
I'm using the Veritas Mk II sharpening jig. After flattening the back, I'm setting a 25 degree bevel first on the 300 and then 1000 stone. When I go to do the micro-bevel it's clear that something is not straight based on the results. I've gone through the process several times with consistent results.
I've double checked that the chisel is sits square to the fence (both before & after), and am tightening the clamp knobs evenly. I'm applying even pressure to both sides of the chisel.
What am I doing wrong?
IMG_20190220_211041.jpg